How to remove front and rear bumper Mercedes GLA X156

Depending on the year of release of the attachment can vary.

Front bumper

-open the hood.

-under the hood, Unscrew the five screws that secure the top.

-around the bottom part Unscrew the seven screws (spun up) that secure the lower part.

-free lining of the wings of the bumper (hold on the latch, simply pull on yourself).

-wrenched the wheel to the side.

-wheel arches pulled three pistons on each side and removed the wheel arches (the front part).

-attach the fender liner to the side and Unscrew two screws on each side (spun upwards) holding the corners of the bumper to the wings.

-release the clips under the headlights (pull the bumper forward).

-with the assistant pulls the bumper forward (look for wires).

-release the connectors on the Parking sensors, fog lights, temperature sensor (if any).

Rear bumper

-open the trunk lid.

-in the trunk, Unscrew the screws and remove the rear trim panel.

-for the casing, through the holes in the rear panel, Unscrew the two nuts.

-Unscrew the four screws (twisted up) and take out the rivets that attach the lower part.

-free lining of the wings of the bumper (hold on the latch, simply pull on yourself).

-wheel arches take out two pistons on each side and removed the wheel arches (rear).

-move the wing flaps to the side and Unscrew one screw on each side (spun upwards) holding the corners of the bumper to the wings.

-we release the latch in the wings (pull the corners themselves).

-with the assistant pulls the bumper backwards (look for wires).

-snap together the connectors of electrical equipment.