How to remove front and rear bumper Mercedes GLK X204

Depending on the year and configuration of the attachment locations can vary.

Front bumper

-open the hood.

-under the hood, remove the pads and Unscrew the six screws that secure the top.

-around the bottom part Unscrew the screws and take out the rivets that attach the fender liner and protection.

-for protection Unscrew two hidden screws (spun in the direction from the engine).

-wrenched the wheel to the side.

-wheel arches pulled three pistons on each side and removed the wheel arches (the front part).

-attach the fender liner to the side and Unscrew two screws on each side (spun upwards) holding the corners of the bumper to the wings.

-release the fasteners in the wings (pull the corners of the bumper down and yourself).

-with the assistant pulls the bumper forward (look for wires).

-release the connectors on the Parking sensors, fog lights, temperature sensor (if any).

Rear bumper

-open the trunk lid.

-in the trunk remove the plastic cover of the rear panel.

-for the casing, through the holes in the rear panel, Unscrew the four nuts.

-in the side casings open the cap, Unscrew them by three nuts on each side and remove the tail lights.

-Unscrew the six screws (spun up) that secure the lower part.

-wheel arches take out the caps and removed the wheel arches (rear).

-move the wing flaps to the side and Unscrew one screw on each side (spun upwards) holding the corners of the bumper to the wings.

-we release the latch in the wings (pull the corners themselves).

-release the clips under the rear lights (need to pry with a screwdriver). You can also Unscrew two nuts on each side behind the side panels and remove the bumper with brackets, then the rear lights should not be removed.

-with the assistant pulls the bumper backwards (look for wires).

-snap together the connectors of electrical equipment.