How to remove front and rear bumper Mercedes CLS C218

Depending on the year and configuration of the attachment locations can vary.

Front bumper

-open the hood.

-under the hood with a flat head screwdriver release the latches that secure the upper part.

-Unscrew the screws and remove the motor protection.

-for protection Unscrew the two screws of fastening of a bumper.

-take out the caps in the lower part (inserted from the bottom up) holding the fender liner.

-wrenched the wheel to the side.

-wheel arches take out the caps and removed the wheel arches (the front part).

-for wheel arch liners Unscrew two screws on each side (spun upwards) holding the corners of the bumper to the wings.

-release the fasteners in the wings (pull down and towards you).

-with the assistant pulls the bumper forward (look for wires).

-release the connectors for fog lamps (easier to remove chocks from light bulbs), turn signals, Parking sensors and temperature sensor (if any).

-if you have headlight washers, disconnected the hoses.

Rear bumper

-open the trunk lid.

-in the trunk Unscrew two nuts, remove the two clips and remove the trim up the rear.

-for covering the back panel, through the holes, Unscrew the two nuts.

-through the opening in the right trim trunk releasable connectors sensors.

-Unscrew the screws around the perimeter of the bottom (spun up).

-wheel arches take out the caps, Unscrew the screws and removed the fender liner (rear part).

-for wheel arch liners Unscrew one screw on each side (spun upwards) holding the corners of the bumper to the wings.

-we release the latch in the wings (pull the corners themselves) and under the rear lights.

-with the assistant pulls the bumper backwards (look for wires).

-take out the plugs of electrical equipment.

How to remove front and rear bumper Mercedes CLS C219