Depending on the year of release of the attachment can vary.
Front bumper
-open the hood.
-under the hood take out the six rivets that attach the upper part.
-Unscrew the two screws and take out the four clips (twisted and inserted from the bottom up) that secure the lower part.
-depending on what direction we will analyze wrenched the wheel to the side.
-wheel arches, peel the fender liner.
-for wheel arch liners Unscrew one screw on each side that attach the angles to the wings.
-we release the latch in the wings (pull the corners themselves).
-release the clips under the headlights.
-with the assistant pulls the bumper forward (looking to not break the wires and hoses).
-remove the connectors from the fog lights (if any).
-(if any) disconnected hoses to the washer (can leak fluid).
Rear bumper
-open the trunk lid.
-in the opening of the trunk, Unscrew the screws (depending on year, if any)
-around the bottom part Unscrew four screws and take out the two pistons.
-wheel arches, peel the fender liner.
-for wheel arch liners Unscrew one screw on each side (spun upwards) holding the corners of the bumper to the wings.
-we release the latch in the wings (pull the corners themselves).
-release the clips under the rear lights and opening boot.
-with the assistant gently pulls the back bumper (don't want to break the wires).
-remove the connectors from the equipment (if any).
How to remove front and rear bumper Acura RL (1996-2004)