How to remove front and rear bumper Acura TL (Honda Inspire) (1998-2003)

Depending on the year the site of attachment may vary slightly.

Front bumper

-open the hood.

-under the hood take out ten of clips (inserted from top to bottom) that secure the cover plate over the grille.

-take out the two clips that secure the upper part.

-Unscrew the two screws and remove six caps (twisted and inserted from the bottom up) that secure the lower part to the wheel arches and protection.

-wrenched the wheel to the side.

-wheel arches, peel the fender liner.

-move the wing flaps to the side and  Unscrew one screw on each side that attach the angles to the wings.

-we release the latch in the wings.

-release the clips under the headlights.

-with the assistant pulls the bumper forward (don't want to break the wires and hoses).

-remove the connectors from the fog lights (if any).

-(if any) disconnected hoses to the washer (can leak fluid).

Rear bumper

-open the trunk lid.

-in the opening of the trunk pulls out five caps.

-floor pull out two pistons (inserted from the bottom up).

-wheel arches Unscrew one screw on each side and removed the fender liner.

-move the wing flaps to the side and Unscrew one screw on each side (spun upwards) holding the corners of the bumper to the wings.

-we release the latch in the wings (pull the corners themselves).

-release the clips under the rear lights.

-with the assistant gently pulls the back bumper (don't want to break the wires).

-remove the connectors from the light plate.

How to remove front and rear bumper Acura TL (2004-2008)

How to remove front and rear bumper Acura TL (2008-2014)