How to remove front and rear bumper Acura MDX (2006-2013)

Front bumper

-open the hood.

under the hood, take out nine clips and remove the trim above the grille.

under the pickguard, Unscrew the two screws and take out the two pistons.

-around the bottom part Unscrew the two screws and take out nine of the caps (twisted and inserted from the bottom up).

-depending on what direction we will analyze wrenched the wheel to the side.

-in the wheel wells, Unscrew the screws and peel the fender liner.

-attach the fender liner to the side and Unscrew one screw on each side that attach the angles to the wings.

-we release the latch in the wings (pull the corners themselves).

-with the assistant pulls the bumper forward (don't want to break the wires and hoses).

-remove the connectors from the fog lights (if any).

-(if any) disconnected hoses to the washer (can leak fluid).

Rear bumper

-open the trunk lid.

-take out the cap, Unscrew two of wine and remove the tail lights.

-in the opening of the trunk take out the plugs and Unscrew the four screws.

-take out two pistons (inserted from the bottom up) at the bottom.

-in the wheel wells, Unscrew the screws and take out the rivets that attach the fender liner and mud flaps.

-Unscrew one screw on each side (spun upwards) holding the corners of the bumper to the wings.

-we release the latch in the wings (pull the corners themselves).

-release the clips under the rear lights and opening boot.

-with the assistant gently pulls the back bumper (don't want to break the wires).

-remove the connectors from the equipment (if any).

How to remove front and rear bumper Acura MDX (2001-2006)

How to remove front and rear bumper Acura MDX (2014-2020)