How to remove front and rear bumper Acura TL (2008-2014)

Depending on the year the site of attachment may vary slightly.

Front bumper

-open the hood.

-under the hood, take out the clips, release the clips and remove the pads (need to access the top mounts of the bumper).

-under the covers Unscrew the four screws that secure the top.

-at the bottom, Unscrew the two screws (spun up).

-wrenched the wheel to the side.

-wheel arches take out two pistons on each side and removed the fender liner.

-move the wing flaps to the side and  Unscrew one screw on each side that attach the angles to the wings (spun up).

- we release the latch in the wings (pull the corners themselves).

-release the clips under the headlights (pull back on the angle and pull on yourself).

-with the assistant pulls the bumper forward (don't want to break the wires and hoses).

-a detachable temperature sensor.

-remove the connectors from the fog lights (if any).

-switched the hoses to the washer (can leak fluid).

Rear bumper

-floor pull out two pistons (inserted from the bottom up).

-wheel arches Unscrew three screws on each side (so as not to remove wheel remove better ratchet with a nozzle) and free lockers.

-move the wing flaps to the side and Unscrew one screw on each side (spun upwards) holding the corners to the wings.

- pull the corners into themselves  and release the latch in the wings.

-release the clips under the rear lights and opening boot (pull back).

-with the assistant gently pulls the back bumper (don't want to break the wires).

-remove the electrical connector license plate light.

-remove the connectors from the sensors (if any).

How to remove front and rear bumper Acura TL (Honda Inspire) (1998-2003)

How to remove front and rear bumper Acura TL (2004-2008)