-we take out the eight pins that secure the trim and the upper part of the front bumper.
-bend the rubber pads above the headlights and unscrew one screw under them on each side (take out the plastic clips) that secure the sides to the wings.
-from the bottom, unscrew ten screws (twisted from bottom to top) that secure the lower part.
-turn the wheels to the side.
-in the wheel arches we take out the pistons and release the fender liners (front part).
-move the fender liners to the side and unscrew one screw on each side (twisted from bottom to top) that secure the corners of the bumper to the wings.
-release the latches in the wings (pull the corners toward you).
-release the latches under the headlights and above the headlights.
-with an assistant, carefully pull the bumper forward (watch the wires).
-on the right side in the direction of travel, disconnect the two electrical connectors.
-we release the connectors of the fog lights.
Rear bumper
-open the trunk lid.
-remove the covers near the rear lights (they are held on by latches, you need to pull them towards you).
-under the trims, unscrew the two screws that secure the upper part of the rear bumper and the four screws that secure the rear lights.
-release it from the clamps (indicated by blue arrows) and remove the rear lights.
-under the rear lights, pull out two pistons on each side.
-from the bottom, unscrew the two screws and take out the two pistons (twisted and inserted from the bottom up) that secure the lower part.
-in the wheel arches, pull out two pistons on each side and release the fender liners (rear part).
-pull off the fender liners and unscrew one screw on each side (twisted from bottom to top) that secure the corners to the wings.
-release the latches in the wings (pull the corners toward you).
-release the latches in the trunk opening.
-with an assistant, pull the bumper back (watch the wires).
-disconnect the connectors of the electrical equipment (if any).
English 
Italiano 
Français 
русский 
Deutsch 
Español 
