-
-
-
Infiniti (Y51) M25 / M37 / M56 / M35h / M30d / Q70 (2010-2019)
Front bumper
-open the hood.
-under the hood we take out the six pistons (inserted from top to bottom) that secure the upper part of the front bumper.
-bend the covers above the headlights, unscrew one screw on each side and take out the plastic clips.
-from the bottom side, unscrew the twelve screws that secure the lower part.
-turn the wheels to the side.
-in the wheel arches we release the fender liners (front part).
-move the fender liners to the side and unscrew one screw on each side (twisted from bottom to top) that secure the corners to the wings.
-release the latches in the wings (pull the corners yourself).
-release the latches under the headlights.
-with an assistant, carefully pull the bumper forward (watch the wires and hoses).
-disconnect the connectors of the electrical equipment.
-(if any) disconnect the headlight washer hoses (liquid may leak).
Rear bumper
-open the trunk lid.
-remove the covers near the rear lights (they are held on by latches).
-in the trunk, release the side trims (you need to gain access to the back of the rear lights).
-behind the casings, unscrew the nuts, release them from the clamps and remove the rear lights.
-unscrew the two screws and take out the four pistons that secure the upper part of the rear bumper.
-unscrew the four screws and take out the three pistons (twisted and inserted from bottom to top) that secure the lower part.
-release the latches in the wings (pull the corners toward you).
-release the latches in the trunk opening.
-with an assistant, pull the bumper back (watch the wires).
-disconnect the parking sensor connectors (if equipped).
English 
Italiano 
Français 
русский 
Deutsch 
Español