-
-
Front bumper
-open the hood.
-take out the caps (inserted from top to bottom) that secure the upper part.
-take out the rivets and remove the lining above the headlights.
-under the covers Unscrew two screws on each side that attach the bumper to the wings.
-on the perimeter at the bottom of the bumper Unscrew the ten screws and take out the five caps.
-wrenched the wheel depending on which side will parse the first.
-in the wheel wells, Unscrew the screws and remove the caps, release of the latches lining of the wings.
- free lockers.
-attach the fender liner to the side and Unscrew one screw on each side (spun upwards) holding the corners to the wings.
-with the assistant gently pulls the bumper itself.
-remove the connectors from the fog lights (if any).
-remove connector from the PDC (if any).
-if you have headlight washers, disconnected the hoses.
-remove connectors with additional electrical equipment (if available).
Rear bumper
-open the trunk lid.
-in the opening removable lining (keep latches).
-under the covers Unscrew two screws on each side.
-remove tail lights.
-the rear lights take out one piston on each side.
-on the perimeter in the bottom part Unscrew the two screws and take out nine of the caps (twisted and inserted from the bottom up).
-in the wheel wells, Unscrew the screws and release the latches lining arches.
-free lockers and Unscrew one screw from each side (spun upwards) holding the corners of the bumper to the wings.
-assistant free the bumper from the clips in the wings and gently pulls on itself.
-remove the electrical connectors (if any).
English 
Italiano 
Français 
русский 
Deutsch 
Español