Infiniti QX70 (2013-2017) bumper removal.

Front bumper

-open the hood.

-under the hood, take out the six pistons and unscrew the four screws that secure the upper part of the front bumper.

-bend the rubber pads above the headlights and unscrew two screws on each side.

-at the bottom of the bumper, unscrew the screws (twisted from bottom to top).

-turn the wheels to the left or right.

-in the wheel arches, unscrew two screws on each side that secure the arch linings (front part).

-we release the arch linings from the bumper (they are held on by clips, you need to pull them towards you, from bottom to top).

-take out the pistons and release the fender liners (front part).

-behind the fender liners, unscrew one screw on each side (twisted from bottom to top) that secure the corners to the wings.

-release the latches in the wings (pull the corners toward you).

-release the latches under the headlights (pull towards yourself).

-release the fasteners under the hood.

-with an assistant, carefully pull the bumper forward (watch the wires and hoses).

-we release the connectors of the electrical equipment.

-if there are headlight washers, disconnect the hoses (note that liquid may leak from the reservoir).

Rear bumper

-open the trunk lid.

-in the trunk opening, remove the plastic covers near the rear lights.

-under the trims, unscrew the four screws that secure the rear lights.

-remove the rear lights (they are held on by two clips in the wings each).

-take out the two pistons and unscrew the four screws that secure the upper part of the rear bumper.

-from the bottom we take out the nine pistons that secure the lower part and unscrew the two screws that secure the arch trims.

-we unscrew two screws on each side in the wheel arches and release the arch linings from the bumper (they are held on by latches, we pull them towards us from the bottom up).

-move the fender liners to the side and unscrew one screw on each side (twisted from bottom to top) that secure the corners to the wings.

-release the latches in the wings (pull the corners toward you).

-we release the latches in the trunk opening (you need to remove the lower part of the trunk seal and press the five yellow latches with a flat screwdriver).

-with an assistant, pull the rear bumper back (make sure not to break the wires).

-disconnect the connectors of the electrical equipment.