Depending on the year of release of the attachment can vary.

Front bumper

-open the hood.

-under the hood remove the pickguard (if any)

-take out seven rivets (inserted upside down) and Unscrew the headlights, one screw on each side that secure the upper part.

-on the perimeter at the bottom of the bumper Unscrew the ten screws (spun up).

-wrenched the wheel depending on which side will parse the first.

-wheel arches, peel the fender liner.

-attach the fender liner to the side and Unscrew one screw on each side (spun upwards) holding the corners to the wings.

-with the assistant release the latch in the wings (pull on yourself), and gently pulls the bumper.

-remove the connectors from the fog lights (if any).

-remove connector from the PDC (if any).

-if you have headlight washers, disconnected the hoses.

-remove connectors with additional electrical equipment (if available).

the scheme of fastening of the front bumper Infiniti G series (after 2008)

the scheme of fastening of the front bumper Infiniti G series (after 2008)

Rear bumper

-in the boot remove the side trim (you need to access the rear part of the rear lights).

-for casings, Unscrew the nuts and remove the tail lights.

-take out the clips under the rear lights.

-on the perimeter in the bottom part Unscrew the screws and take out the caps (twisted and inserted from the bottom up).

-wheel arches, peel the fender liner.

-for wheel arch liners Unscrew one screw on each side (spun upwards) holding the corners of the bumper to the wings.

-assistant free the bumper from the clips in the fenders (pull on yourself), and gently pulls back.

-remove the electrical connectors.

the scheme of fastening the rear bumper of the Infiniti G series (after 2008)

the scheme of fastening the rear bumper of the Infiniti G series (after 2008)

 

How to remove front and rear bumper Infiniti G series (2002-2007)