How to remove front and rear bumper Subaru B9 Tribeca (2008-2014)

Front bumper

-open the hood.

-under the hood take out two clips and remove the air intake.

-eleven pulls out of clips that secure the trim and the grille, remove the cover.

-take out seven rivets (inserted from the bottom up) that secure the lower part.

-wrenched the wheel depending on which side we understand.

-wheel arches, peel the fender liner.

-the lockers take out one piston on each side (inserted from the bottom up) holding the corners of the bumper to the wings.

-with the assistant release the latch in the wings (pull the corners on himself) and pulls the bumper forward (don't want to break the wires).

-remove the connectors from the equipment (if any).

Rear bumper

-open the trunk lid.

-take out four of the pistons (inserted from the bottom up) that secure the lower part.

-wheel arches, peel the fender liner.

-the lockers take out one piston on each side (inserted from the bottom up) holding the corners of the bumper to the wings.

-with the assistant release the latch in the wings and under the tail lamps.

-gently pulls the bumper back.

-snap together the connectors of the equipment (if any).

How to remove front and rear bumper Subaru B9 Tribeca (2005-2007)