How to remove front and rear bumper Subaru BRZ

Depending on the year of manufacture, the attachment points may vary slightly.

Front bumper

-open the hood.

-under the hood take out two pistons and Unscrew the five screws that secure the top of the bumper.

-take out the seven caps and unscrew the two wines (twisted and inserted from the bottom up) at the bottom.

-turn the wheels depending on which side we will disassemble.

-wheel arches take out four pistons on each side that attach the fender liner and side of the bumper to the wings.

-we release the latches in the wings and under the headlights (pull the corners of the bumper towards you).

-with an assistant, pull the bumper forward (look for the wires).

-disconnect electrical connectors (if any).

Rear bumper

-unscrew the two screws in the opening of the trunk.

-in the trunk, under the floor trim, disconnect the electrical connector.

-around the perimeter of the lower part of the bumper take out ten caps.

-take out the caps in the wheel arches that attach the fender liner (rear) and bumper corners to the wings.

-we release the latches in the wings, under the rear lights and in the opening of the trunk (pull the corners of the bumper towards you).

-with an assistant, we pull the bumper back (look for the wires, you need to pull the wire out of the trunk from the bottom side).