Front bumper

-open the hood.

-under the hood, take out the clips that secure the panel and top, remove the plate.

-wrenched the wheel depending on which side we understand.

-wheel arches, peel the fender liner.

-the lockers take out one piston on each side (inserted from the bottom up) holding the corners of the bumper to the wings.

-take out seven rivets (inserted from the bottom up) that secure the lower part.

-with the assistant release the latch in the wings (pull the corners on himself) and pulls the bumper forward (don't want to break the wires).

-remove the connectors from the equipment (if any).

the scheme of fastening of the front bumper of the Subaru Tribeca B9 (2005-2007)

the scheme of fastening of the front bumper of the Subaru Tribeca B9 (2005-2007)

the scheme of fastening of the front bumper of the Subaru Tribeca B9 (2005-2007)

the scheme of fastening of the front bumper of the Subaru Tribeca B9 (2005-2007)

Rear bumper

-open the trunk lid.

-in the opening of the trunk and pull out the pistons and remove the pads.

-take out the rivets that attach the lower part.

-wheel arches, peel the fender liner.

-the lockers take out one piston on each side (inserted from the bottom up) holding the corners of the bumper to the wings.

-with the assistant release the latch in the wings, and gently pulls the bumper back.

-snap together the connectors of the equipment (if any).

the scheme of fastening of the rear bumper Subaru Tribeca B9 (2005-2007)

the scheme of fastening of the rear bumper Subaru Tribeca B9 (2005-2007)

the scheme of fastening of the rear bumper Subaru Tribeca B9 (2005-2007)

the scheme of fastening of the rear bumper Subaru Tribeca B9 (2005-2007)