Screws and nuts are strongly sour, so before removing the need to handle hardware "liquid wrench".
Depending on the year and model of the attachment may vary slightly.
-open the hood.
-under the hood, Unscrew the four screws and remove the panel above the grille.
-under the panel Unscrew the four screws and remove the grille, release and remove the lining under the lights.
-around the bottom part Unscrew the six screws (spun up).
-depending on which side we will disassemble, wrenched the wheel.
-Unscrew the screws in the wheel arches that secure the fender liner.
-Unscrew two nuts on each side that attach the angles to the wings (easier to Unscrew from the bottom).
Then you can remove either with power or without.
-Unscrew the two screws under the license plate and the two screws in the grille of the bumper.
-pulls the bumper forward (don't want to break the wires).
-remove the connectors of the fog lights.
-remove fog lights.
-through the openings of the fog light, Unscrew two nuts from each side that secure the amplifier to the body.
-wheel arches Unscrew the screws that attach the fender liner.
-for wheel arch liners Unscrew two nuts on each side that attach the angles to the wings.
-there might be two options for mounting. Floor Unscrew two nuts on each side that attach the bumper reinforcement to the body, or Unscrew the two screws under the license plate that secures the bumper to the amplifier.
-with an assistant pull the corners to the side and gently pulls the back bumper (don't want to break the wires).
-remove the connectors from the light plate (if any).