How to remove front and rear bumper of Lada (VAZ) 2110, 2111, 2112

Screws and nuts are strongly sour, so before removing the need to handle hardware "liquid wrench".

Front bumper

-open the hood.

-under the hood, Unscrew the two screws and pull up the grille.

-under the grille, Unscrew the two screws (you can not fully remove, just loosen a few turns).

-depending on which side we will disassemble, wrenched the wheel.

-Unscrew the screws in the wheel arches and on one side of the bottom that attach the fender liner to the bumper.

-Unscrew one screw on each side that attach the angles to the wings (easier to Unscrew from the bottom).

-Unscrew the five nuts that secure the protection of the motor (just loosen a few turns).

-pulls the bumper forward (don't want to break the wires).

-remove the connectors of the fog lights.

Rear bumper

-open the trunk lid.

-in the opening of the trunk, Unscrew the screws that secure the top.

-Unscrew the two nuts (spun up) that secure the lower part.

-pulls off corners with the locks in the wings (pull back)

-gently pulls back bumper (don't want to break the wires).

-remove the connectors from the light plate.