How to remove front and rear bumper Lada (VAZ), Vesta (Vesta SW Cross)

Front bumper

-open the hood.

-under the hood, Unscrew the six screws (spun down) that secure the upper part.

-around the bottom part Unscrew the eight screws (spun upwards) holding the lockers and the center lower part of the body.

-depending on what direction we will analyze wrenched the wheel to the side.

-wheel arches Unscrew two screws on each side holding the fender liner.

-remove the license plate and Unscrew under them two screws.

-we release the latch in the wings (pull the corners themselves).

-pulls the bumper forward (don't want to break the wires).

-remove the connectors from the fog lights and temperature sensor (if any).

Rear bumper

-open the trunk lid.

-in the side panels openable hatches (to gain access to the rear part of the rear lights).

-Unscrew three nuts from each side and take out the back tail lights.

-under the rear lights Unscrew one screw on each side.

-Unscrew the screws around the perimeter of the opening of the trunk.

-Unscrew the two screws in the Central bottom part (spun up), which is attached to the body and edges of the lower parts that attach the fender liner.

-wheel arches Unscrew the screws that attach the fender liner.

-we release the latch in the wings (pull the corners themselves).

-with the assistant gently pulls the back bumper (don't want to break the wires).

-remove the connectors from the sensors and lighting (if any).