Depending on the year of release of attachment is different.
-open the hood.
-under the hood, Unscrew the three (or four, depending on the year) screw and take out one of the clips that secure the upper part.
-around the bottom part Unscrew the screws (spun up) that secure the protection (can be unscrewed far the screws and remove the bumper with the cover).
-wrenched the wheel to the side.
-wheel arches Unscrew three screws on each side and removed the wheel arches (the front part).
-(after 2011) with the wing flaps Unscrew two screws on each side holding the corners of the bumper to the wings (two screws swirling up from the bottom and one side of the engine).
-(up to 2011) release latch in the wings (pull the corners of the bumper itself).
-with the assistant pulls the bumper forward (look for wires and hoses).
-snap together the connectors of electrical equipment.
-if you have headlight washers, disconnected the hoses.
-open the trunk lid.
-remove tail lights.
-remove the plastic cover of the rear panel.
-Unscrew the two nuts from the trunk.
-Unscrew the two screws and take out the four clips that secure the lower part.
-in the wheel wells, Unscrew the screws holding the wheel arch liners and the bumper to the wings.
-we release the latch in the wings (pull the corners themselves).
-with the assistant pulls the bumper backwards (look for wires).
-snap together the connectors of the equipment (if any).