Depending on the year the site of attachment may vary slightly.

Front bumper

-open the hood.

-under the hood the four screws (spun down) that secure the upper part and the grille, release the latch.

-we release the two clips, between the radiator and the grille and remove the grille.

-around the bottom part Unscrew the screws (spun up) that secure the protection.

-wrenched the wheel to the side.

-in the wheel wells, Unscrew the screws and peel the fender liner (front part).

-we release the latch in the wings (pull the corners in and forward, you need to make the effort).

-with the assistant pulls the bumper forward (look for wires and hoses).

-snap together the connectors of electrical equipment.

-if you have headlight washers, disconnected the hoses.

the attachment of the front bumper Jaguar XJ X350/X358

The scheme of fastening of the front bumper Jaguar XJ X350/X358

 

Rear bumper

⇒Tips for removing bumpers and how to avoid breaking anything..⇐

-open the trunk lid.

-take out the caps and remove the rear trim panel.

-the casing Unscrew the four screws.

-Unscrew the four screws in the bottom (spun up).

-in the wheel wells, Unscrew the screws holding the fender liner (rear part).

-we release the latch in the wings (pull the corners into themselves and back, you need to make an effort).

-with the assistant pulls the bumper backwards (look for wires).

-snap together the connectors of the sensors (if any).

 the attachment of the rear bumper Jaguar XJ X350/X358

The scheme of fastening of the rear bumper Jaguar XJ X350/X358

 

How to remove front and rear bumper Jaguar XJ (X308)

How to remove front and rear bumper Jaguar XJ (X351)