Depending on the model year and body type of attachment may vary.
-open the hood.
-under the hood, Unscrew the eight screws and take out one of the clips that secure the upper part.
-at the bottom, Unscrew the three screws that secure the protection of the engine and the screws that attach the fender liner.
-wrenched the wheel to the side.
-in the wheel wells, Unscrew the screws and peel the fender liner (front part).
-for wheel arch liners Unscrew three screws on each side holding the bumper corners to the wings.
-with the assistant pulls the bumper forward (look for wires).
-release the electrical connectors.
-if you have headlight washers, disconnected the hoses.
-open the trunk lid.
-remove the lining near the tail lights.
-take out the caps in the opening of the trunk.
-Unscrew the screws around the perimeter of the bottom.
-in the wheel wells, Unscrew the screws and peel the fender liner (rear part).
-the fender liner, Unscrew the screws that attach the sides to the wings.
-we release the latch in the wings (pull the corners themselves).
-with the assistant pulls the bumper backwards (look for wires).
-snap together the connectors of electrical equipment.