-
-
-
Depending on the model year and body type of attachment may vary.
Front bumper
-open the hood.
-under the hood, Unscrew the six screws that secure the top.
-at the bottom, Unscrew the eleven screws that secure the motor protection.
-if you have headlamp washers, remove the nozzle and remove the cap.
-wrenched the wheel to the side.
-in the wheel wells, Unscrew the screws and peel the fender liner (front part).
-for wheel arch liners Unscrew two screws on each side that attach the angles to the wings.
-with the assistant pulls the bumper forward (look for wires).
-release the electrical connectors.
Rear bumper
-open the trunk lid.
-in the trunk take out the caps and remove the rear trim panel.
-the plating Unscrew three nuts.
-Unscrew the screws around the perimeter of the bottom.
-in the wheel wells, Unscrew the screws and peel the fender liner (rear part).
-for wheel arch liners Unscrew two screws on each side.
-release the latches and the latches in the wings.
-with the assistant pulls the bumper backwards (look for wires).
-snap together the connectors of electrical equipment.
English 
Italiano 
Français 
русский 
Deutsch 
Español