How to remove front and rear bumper Jaguar XJ (X351)
Depending on the year the site of attachment may vary slightly.
Front bumper
-open the hood.
-under the hood, Unscrew the six screws and take out one of the clips that secure the upper part.
-around the bottom part Unscrew ten screws (spun up) that secure the protection. You can Unscrew far the screws and remove the bumper with the cover.
-wrenched the wheel to the side.
-wheel arches Unscrew five screws on each side, and removed the arch liners (the front part).
-move the wing flaps to the side and Unscrew two screws on each side (one screw is twisted from the bottom up and one on the engine side) that attach the angles to the wings.
-release the fasteners in the wings (pull the corners down and towards you).
-with the assistant pulls the bumper forward (look for wires and hoses).
-snap together the connectors of electrical equipment.
-if you have headlight washers, disconnected the hoses.
Rear bumper
-open the trunk lid.
-raise the boot floor and in the alcove to free the connectors on the sensors.
-in the trunk, Unscrew three nuts on each side and remove the tail lights.
-under the rear lights Unscrew the top of the bumper.
-Unscrew the six screws from the bottom (spun up).
-wheel arches Unscrew three screws on each side holding the fender liner (rear part).
-the fender liner, Unscrew the screws holding the corners of the bumper to the wings.
-we release the latch in the wings (pull the corners themselves).
-with the assistant pulls the bumper backwards (look for wires).
-snap together the connectors of electrical equipment.
English 
Italiano 
Français 
русский 
Deutsch 
Español 
