Depending on the year the site of attachment may vary slightly.
-open the hood.
-under the hood release latch and remove the grille.
-Unscrew the screws and remove the headlamp.
-detach the washer hoses (if any).
-behind the headlights, Unscrew the two screws (twisted from top to bottom) that fasten the amplifier bumper to the body.
-around the bottom part Unscrew the screws that secure protection.
-wrenched the wheel to the side.
-in the wheel wells, Unscrew the screws, and removed the fender liner (front part).
-with the assistant pulls the bumper forward from the rails in the wings (look for wires).
-snap together the connectors of electrical equipment.
-open the trunk lid.
-in the trunk remove the plastic cover of the rear panel.
-the plating of the rear panel Unscrew the four nuts that secure the amplifier bumper to the body.
-in the wheel wells, Unscrew the screws (drilled the rivets) holding the fender liner.
-with the assistant gently pulls the bumper back with the latches in the wings (look for wires).
-snap together the connectors of the equipment (if any).