How to remove front and rear bumper Saturn Aura

Depending on the year the site of attachment may vary slightly.

Front bumper

-open the hood.

-under the hood, Unscrew the six screws and take out the two clips that secure the upper part.

-from the bottom Unscrew the screws and take out the rivets that attach the lower part.

-wrenched the wheel to the side.

-wheel arches Unscrew the screws that attach the fender liner.

-attach the fender liner to the side and Unscrew one screw on each side holding the bumper corners to the wings.

-we release the latch in the wings (pull the corners themselves).

-with the assistant pulls the bumper forward (look for wires and hoses).

-snap together the connectors of the equipment (if any).

-switched the hoses to the headlight washers (if any).

Rear bumper

-open the trunk lid.

-in the side panels of the trunk open the cap, Unscrew three nuts on each side and remove the tail lights.

-remove the plastic cover of the rear panel.

-for the plating, from the side of the trunk, Unscrew the four nuts.

-Unscrew the screws (rivets) from the bottom.

-in the wheel wells, Unscrew the screws holding the fender liner (rear part).

-for wheel arch liners Unscrew one screw on each side holding the bumper corners to the wings.

-we release the latch in the wings (pull the corners themselves).

-using a flat screwdriver release the clips under the rear lights.

-with the assistant gently pulls the bumper backwards (look for wires).

-snap together the connectors of the equipment (if any).