How to remove front and rear bumper Jeep Renegade

Depending on the year of release of the attachment can vary.

Front bumper

The bumper is removed along with the grille.

-open the hood.

-under the hood, take out the four clips above the headlights and Unscrew the four screws that secure the grille.

-wrenched the wheel to the side.

-in the wheel arches on each side, Unscrew one screw that secure the lining of the wings and two holding the fender liner.

-pull on yourself and release the lining of the wings of the clips in the bumper (completely remove not boring).

-under lining of the wings Unscrew two screws on each side.

-Unscrew the screws around the perimeter of the bottom (spun up).

-pull the corners into themselves and release the slits for the wings.

-with the assistant pulls the bumper forward (pay attention to wire).

-remove connectors from electrical equipment.

Rear bumper

-open the trunk lid.

-side panels removable access doors.

-for hatches, Unscrew the fasteners and remove the rear lights.

-under the rear lights Unscrew one plastic nut on each side.

-in the opening of the trunk, Unscrew the four screws.

-wheel arches Unscrew three screws on each side (will need a ratchet with a nozzle) that attach the fender liner to the bumper.

-released from the latches to the bumper lining of wings (completely remove is not necessary).

-under the covers, Unscrew the screws that attach the angles to the wings.

-around the bottom part Unscrew the screws (spun up).

-with the assistant pulls the back bumper (don't want to break the wires).

-snap together the connectors of the equipment (if any).