How to remove front and rear bumper Jeep Commander

Depending on the year of release of the attachment can vary.

Front bumper

-open the hood.

-under the hood take out six rivets and remove the radiator grille.

-under the grille, Unscrew the four screws that secure the upper part of the bumper.

-wrenched the wheel to the side.

-wheel arches take out two pistons on each side that attach the fender liner.

-for wheel arch liners Unscrew one screw on each side holding the bumper corners to the wings.

-Unscrew the two screws (spun up) that secure the lower part.

-with the assistant pulls the bumper forward (don't want to break the wires).

-snap together the connectors of the equipment (if any).

Rear bumper

-open the trunk lid.

-in the opening of the trunk Unscrew two screws and take out the four clips.

-wheel arches take out the rivets that secure the lining of the wings (moldings).

-is released from the latch (pull to yourself) and remove the lining of the wings (moldings).

-wheel arches take out the rivets that attach the fender liner and mud flaps.

-take out the rivets that attach the lower part.

-peel the corners of the clips and with the assistant pulls the back bumper (don't want to break the wires).

-snap together the connectors of the sensors (if any).