Front bumper

Removed the bumper without grille.

mounting locations for front bumper Jeep Grand Cherokee WK2 (after 2011)

-wrenched the wheel, depending on which side we understand.

-wheel arches and drilled the two rivets.

-is released from the latch in the bumper pads of the wings (pull over), fully lining can not be removed.

-wheel arches Unscrew one screw on each side that attach the angles to the wings and take out one striker (need rotate 90 degree).

-perimeter of the lower part and pull out the caps.

-we release the latch in the wings (pull the corners over), under the headlights and under the grille.

-with the assistant pulls the bumper forward (pay attention to wire).

-remove the connectors from the equipment (if any).

the scheme of fastening of the front bumper of the Jeep Grand Cherokee WK2 (after 2011)

the scheme of fastening of the front bumper of the Jeep Grand Cherokee WK2 (after 2011)

the scheme of fastening of the front bumper of the Jeep Grand Cherokee WK2 (after 2011)

Rear bumper

the attachment of the rear bumper Jeep Grand Cherokee WK2 (after 2011)

-open the trunk lid.

-Unscrew the two screws in the opening of the trunk.

-wheel arches take out the caps and Unscrew the screws that attach the fender liner and trim the fenders to bumper.

-is released from the latch (pull to yourself) and remove the lining of the wings (might have to drill out rivets).

-over plates of wings Unscrew one screw on each side.

-around the bottom part Unscrew the screws (depending on year, the number of changes).

-we release the latch in the wings (pull the corners themselves).

-with the assistant pulls the back bumper (don't want to break the wires).

-snap together the connectors of electrical equipment.

diagram of rear bumper Jeep Grand Cherokee WK2 (after 2011)

diagram of rear bumper Jeep Grand Cherokee WK2 (after 2011)

diagram of rear bumper Jeep Grand Cherokee WK2 (after 2011)